
Dustbin Mould
Welcome to the online message! Please fill in your contact information and suggestions! Thank you!
Contact UsBin bodies and lids need uniform wall thickness to avoid warping and sink marks; cavity dimensions are adjusted after mould-flow simulation for the actual plastic grade.
Hinge bosses, pedal pivots and wheel-axle inserts are designed into the tool, with slider mechanisms where undercuts make ejection impossible otherwise.
Texture is applied to the cavity per your sample or a standard grain chart, and polished areas are protected during transport.
Lid-to-body fit is verified on the T1 samples with a gap and flushness check before the mould is released.